ABHISHEK ENTERPRISES
Decide with Confidence
  • 1
  • 2
  • 3
1 2 3

Electrical Control Panels Manufactures


Automatic Power Factor Control    Panels
Auto Mains Failure Panels
Motor Control Center Panels
Power Control Centers Panels
Synchronizing Panels
we specialize in

• Power Control Centers
• Motor Control Centers
• Capacitor Control Panels
• Bus Ducts Up to 6400 A
• Soft Starter Panels
• VFD Panels
 

Painting / Powder Coating

 
 
PRETREATMENT
 
A)
Seven-tank process is carried out.
   
B)
All the gaps, welding spots, joints are given a coat of m-seal or equivalent finishing material.
   
 
SRAY PAINTINGS
 
A)
Two coats of red oxide are applied across the complete structure
   
B)
The Zinc chromate manufacture by reputed companies like Sigma paints are used (This process is carried out for spray painting only)
   
 
PROCESS TREATMENT
 
A)
The painted structure doors & covers are oven baked.
   
B)
The painted structure is inspected & fault if any are rectified.
   
C)
Panels are randomly tested as per peel off test.
   
D)
It is verified that the structure is hard & scratch proof.
   
E)
The thickness of paint is not less than 50-60 microns approximately
 
POWDER COATING
 
After pretreatment the job is baked for about 70-80 degree centigrade, which enabled to remove the moister contents.
 
After baking the jobs & again baked for about 200 degree centigrade to get the required result.
The powder used is of reputed make like Inter phone, Asian Marpole etc.
 
 
 
We manufacturers and suppliers of Electrical Control Panels and our setup is situated at Dhayari, Pune ( Maharashtra, India )
Designing | Fabrication | Painting Powder Coating | Selection of Busbars | Assembly and Wiring | Testing of Panels